Assembly; Place The Drill Holes - privileg SY-103G1-E1-C59-L52-900 User Manual

Assembly

Place the drill holes

WARNING
Risk of injury!
Improper installation of the appliance
can lead to injury.
Before drilling the holes, ensure that
■
no wires or cables (power, gas, water
etc.) will be damaged (check with a
line locator).
CAUTION
Fire hazard!
The distance between the cooking
■
surfaces and the lower edge of the
hood must be at least 65 cm for gas
stoves.
For gas stovetops, you must read the
■
user manual for the stovetop! If the
manual stipulates a larger distance,
this must be observed.
In order for it to perform to full
capacity, the Exhaust hood
must be placed over the centre of the
cooking zone.
1. In order to place the appliance exactly
over the centre of the stovetop, first use
the pencil to draw a vertical guiding line
on the wall. Ideally, use a level or a plumb
bob from the ceiling of the room to the
middle of the stovetop.
Assembly
Zimmerdecke
2. To keep the prescribed distances, draw
horizontal guides according to the above
diagrams.
27,6 cm
17 cm 7 cm 7 c 7 7 c 7 cm cm
50 cm
38 cm
3. Following the diagram shown above,
draw the eight drill holes on the wall.
Make sure the distances between the
holes are correct.
4. Drill holes at the marked points, using a
diameter that can accommodate the dow-
els.
5. Place the dowels into the holes.
Page EN-11