Installing The Battery; Charging The Battery - Uniden ANA9620 Manual

!
Use only the sealed
lead-acid battery
(part # BT9000) supplied
with this phone.
NOTE
Charge the battery without
interruption for 5 hours.
NOTE
The Charge 1 indicator
light does not go off,
even when the charge
is complete.
All manuals and user guides at all-guides.com

INSTALLING THE BATTERY

1. Remove the battery
cover by pressing
the latch and
sliding the cover
down and off of
the handset.
2. Slide the battery
down into the
handset.
Note: The
system which allows the battery to be replaced while in
operation, as long as it is replaced within 20 seconds.
3. Place the cover
and slide the cover
up until it latches
into the handset.

CHARGING THE BATTERY

The rechargeable sealed lead-acid battery must be fully
charged before using your
1. Place the handset in the front slot of the charging unit.
2. Make sure the
CHARGE 1
lights. If the
CHARGE 1
doesn’t light, check to see that the
AC adapter is plugged in, and that
the handset is making good contact
with the charging unit . Two charge
pockets are available on the
ANA9620, with separate indicator
lights for each. The handset battery
and the second battery may be
charged simultaneously.
ANA9620
has a low battery protection
ANA9620
for the first time.
indicator
indicator
NOTCH