Aligning The Slbu/Slmu On A Projector Using Direct Mounting Option - CHIEF SLMU Installation Instructions Manual

Installation Instructions
STEP 2 (OPTION D)
Aligning the SLBU/SLMU on a Projector using direct
mounting option
Align the SLBU/SLMU on the projector, as follows:
1. Locate the mounting holes on your projector.
2. Using a Phillips screwdriver, remove foot bracket
screws and foot brackets (see Figure 11).
NOTE: Keep unused adjustable foot brackets and
attaching hardware in a safe for future use.
3. Align the SLBU/SLMU on the projector, as follows:
a. Place the SLBU/SLMU (10) on your projector.
b. Adjust the legs on the SLBU/SLMU (10) as
needed. Align the legs on the SLBU/SLMU with
mounting holes on your projector.
4. Attach the SLBU/SLMU to the projector, as follows:
a. Select the screw size that fits the threaded inserts
on your projector (see Table 6).
b. Select the washer that fits the selected screw.
c. Attach the SLBU/SLMU to the projector using
the selected fasteners in accordance with Table 6
(see Figure 12). Do not tighten the screws at this
time.
Table 6. SLBU/SLMU Mounting Hardware
ITEM DESCRIPTION
100
M6 x 20mm Phillips
Pan Head Screw
110 M5 20 P
X MM HILLIPS
P H S
AN EAD CREW
120
M4 x 20mm Phillips
Pan Head Screw
130 M3 20 P
X MM HILLIPS
P H S
AN EAD CREW
QTY NOTES
4
Used with M6 Flat
Washers (70)
4
4
Used with M4 Flat
Washers (80)
4
5. Attach the SLBU/SLMU to RPA/RPM
(see Figure 2).
Figure 11. Remove Feet (SLBU Shown)
Figure 12. Install the SLBU/SLMU on Projector
(SLBU Shown)
SLBU/SLMU
Swing legs inside for
close hole pattern
9