Adjusting Foot Height On Slb-U; Positioning The Slbu/Slmu On The Projector - CHIEF SLMU Installation Instructions Manual

Installation Instructions
STEP 3
Adjusting Foot Height on Bracket
Adjust the feet on the SLBU/SLMU for height, as
follows:
NOTE: Foot height is adjusted for a variety of reasons,
which includes, but is not limited to, ventilation,
uneven projector surface, and to level the
RPA/RPM/RPM mounting plate.
1. Visually check the height of the RPA/RPM mounting
plate on the SLB-U. Review the reasons for foot
height adjustment, noted above.
2. Loosen the screw and adjust the foot that is attached
to the adjustable leg on the SLBU/SLMU
Figure 13).
3. Adjust foot height as needed. If necessary, use a level
to verify that the RPA/RPM/RPM mounting plate is
level.
4. Tighten the screw.
5. Repeat procedure for each foot as needed until the
feet on the SLBU/SLMU are adjusted to your
satisfaction.
STEP 4
Positioning the SLBU/SLMU on
the Projector
Position the on the SLBU/SLMU on your projector, as
follows:
NOTE: When positioning the SLBU/SLMU on your
projector, take into consideration the weight of
the projector and its center of gravity.
1. Slide the SLBU/SLMU into the position that you
want on your projector.
Failure to tighten the screws after positioning the
SLBU/SLMU on your projector could result in
damage to your projector.
2. Tighten the screws shown in Figure 14.
NOTE: For further instructions, see the applicable
RPA/RPM and/or Smart-lift™ instruction
manuals.
10
WARNING
Level the
RPA/RPM/
RPM
Mounting
Plate
(see
Figure 13. Adjust Leg Height
Position bracket on the
projector. Tighten the
screws.
Figure 14. Position the SLBU/SLMU and
Tighten the Screws (SLBU Shown)
SLBU/SLMU
Loosen the screw.
Adjust foot height.
Tighten the screw
(SLBU Shown)