Table of Contents
Advertisement
Available languages
Available languages
IWS 65/ 85
Colour matching
Painting the frame
Using the painting template supplied,
the speakers can be colour matched
to its location. To do this, you should
first remove the speaker grille and fix
the painting template in its place
using decorator's masking tape. Make
sure that no paint spray mist can get
into the side of the speaker.
Repainting the speaker grille
If you also want to repaint the speaker
grille, you should remove the foam
from inside first. The foam is glued on
one side so that you can re-position it
once the paint has dried.
You will find further information about
the
speaker
cables
connections on page 10, Technical
Details.
8
Installation in the Revox Inwall
Back Box [
(for IWS 65; Part. No. 1.084.472.01)
(for IWS 85; Part. No. 1.084.571.01)
If the housing is being installed during
the building phase, we recommend
that you use the corresponding Inwall
Back Box.
! Positioning of IWS 65 !
The positioning of the IWS 65 speaker
cannot be corrected later. Before
installing the Inwall Back Box, check
the speaker position by reference to
the corresponding label inside the
housing.
Speaker cabling
There is a round hole on each side of
the Inwall Back Box with a plastic
sleeve where you can fit 20mm ( 0.79
and
the
in) cabling tubing (EN20 Flexduct).
These should be used for the ducting
for the speaker cabling. You must
ensure that the joint between the
housing and the ducting is completely
tight and that no cement can find its
way in during sealing.
Note:
Not suitable for constructions with
fair-faced concrete.
Re:sound I
optional]
Advertisement
Chapters
Table of Contents
