Iws 85 In Suspended Ceilings - Revox Re:sound I inwall 65 User Manual

IWS 65/ 85
INSTALLATION IWS 85
IWS 85 in a suspended ceiling or recessed in a wall
The IWS 85 consists of two parts; the
base support (mounting frame) and the
speaker front.
Firstly, a cutout, 225 x 330 mm; is made
using the fitting template. You must
ensure that once the speaker has
been fitted, no dirt can get onto the
speaker unit from behind.
Info
The IWS 85 mounting frame has
integrated rotary tensioners for quick
installation. These rotary tensioners are
located on the rear of the speaker and
swivel out through 90° once the marked
screws on the front of the speaker are
screwed in.
Front view
Fig. 1 – Mounting frame
6
Step 1 /
3
The mounting frame is placed in the
cutout opening. Make sure it is lined
up correctly. In Fig. 1 the frame is
shown in a way that later, when the
baffle is placed in position, the
tweeter is at the top.
Tighten the 6 rotary tensioner screws
a little, until the mounting frame is
held in position at the sides. Under no
circumstances should the mounting
frame be twisted.
fitted speaker:
Revox
Don't forget the sound proofing
material.
Back view
Re:sound I