Revox Re:sound I inwall 65 User Manual page 21

IWS 65/ 85
Step 2 /
3
Connect the speaker cable, with the
correct polarity, using the IWS 85
pluggable screw connector. Insert the
screw connector in the corresponding
socket, which is located on the
crossover board on the back of the
baffle.
Step 3 /
3
The last step is to locate the speaker
front on to the mounting frame and fix
it into place at the marked positions
(see Fig. 2) with the 6 screws
supplied. Finally, you place the
speaker grille into
pressing carefully on the edges.
Please do not press in the middle of
the grille  danger of bending.
Lining up the tweeter
The IWS 85 has a tweeter that can be
swivelled to all sides. A non-centralised
position
exceptional cases as the speaker was
position by
developed to be used at the neutral
centre position and lateral reflections
could occur.
Re:sound I
should only
Fig. 2 – Positioning the baffle
be set in
7