Nmea Data Message - FALCOM C2D-SI User Manual

FALCOM C2D-SI
Hex ASCII
0 x A5 165
0 x A6 166
0 x A7 167
0 x B6 182
Table 15:

5.5.2 NMEA data message

The SiRFstarIIe evaluation receiver is capable of outputting data in the
NMEA-0183 format as defined by the National Marine Electronics
Association (NMEA), Standard for Interfacing Marine Electronic Devices,
Version 2.20, January 1, 1997. See "Using the SiRFdemo Software" for
instructions on using NMEA.
NMEA output messages table 16 lists each of the NMEA output messages
supported by the SiRFstarIIe evaluation receiver and a brief description.
Option
GGA
GLL
GSA GPS receiver operating mode, satellites used in the position solution
GSV The number of GPS satellites in view satellite ID numbers, elevation,
MSS Signal-to-noise ratio, signal strength, frequency and bit rate from a
RMC
VTG
Table 16:
This document is a property of FALCOM GmbH and may not be copied or circulated without permission
Name
Set UART Configuration
Set Message Rate
Low Power Acquisition
Parameters
Set UART Configuration
lists the message list for the SiRF output messages
Time, position and fix type data.
Latitude, longitude, UTC time of position fix and status.
azimuth and SNR values.
radio-beacon receiver.
Time, date, position, course and speed data.
Course and speed information relative to the ground.
NMEA Output Messages
Description
Protocol selection, baud rate, data
bits, stop bits and parity
SiRF binary message output rate
Low power configuration parameters
Obsolete
Description
and DOP values.
VERSION 1.07
Page 34