Electrical Connection - Maytag MDB9959SKZ Owner's Manual

5.
Built-up floors – add shims as needed
Built-up floors: If the kitchen floor is higher than the cabinet
opening's floor - for example, the kitchen floor tile does not
extend into the cabinet opening - add shims, as needed, in the
area shown to bring the dishwasher up to 34" (86.4 cm) below
the countertop.
NOTE: Shims must be securely attached to floor to avoid
movement when the dishwasher is in use.
6.
If installing into a 331/2" (85.1 cm)
opening
Cut insulation blanket along perforation for cabinet opening
height of 33½" (85.1 cm). For other cabinet opening heights, do
not cut the insulation blanket.
14

ELECTRICAL CONNECTION

– For Direct Wire, begin with Step 7
– For Power Cord, wait until Step 18
7.
Direct wire – route cable
If installing with direct wire, route the cable as shown. Do not
connect the wire to the product at this time. This connection will
be made later, after the unit is installed into the cabinet opening.
Route cable from power supply through cabinet hole. (Cable
must extend to the right front side of cabinet opening.) Tape
cable to the floor in area shown. This will prohibit cable from
moving when dishwasher is moved into cabinet opening.