Final Installation Check - Maytag MDB9959SKZ Owner's Manual

34.
Install bracket
Bend
tabs
Push bracket into slot on the side of dishwasher, and bend tab in
toward the side of the dishwasher so that it keeps the bracket in
place. Repeat this step for the other side of the dishwasher.
NOTE: Install wood shims to the inside of the cabinets if the gap
between the sides of the cabinet and the sides of the dishwasher
are greater than 1/2" (1.3 cm) on each side.
NOTE: Do not attach the dishwasher. This will be done later.

FINAL INSTALLATION CHECK

35.
Open and close door
36.
Align front of dishwasher with front of
cabinet doors
Align front of dishwasher door panel with front of cabinet doors.
You may need to adjust alignment to be even with your cabinets.
22
37.
Check for plumb and adjust legs if
needed
Check that leveling legs are firmly against the floor. Close and
■
latch the door and place level against the front panel. Check
that dishwasher is centered from front to back in the opening.
If needed, adjust leveling leg until dishwasher is plumb. Repeat
for other side of dishwasher.
With dishwasher plum check that racks do not roll out on their
■
own when you open the door. Adjust front level legs until racks
no longer roll unless you pull them.
Helpful Tip: Push up on front of dishwasher to raise dishwasher
off the ground to adjust front legs. With some installations, it may
be easier to adjust the front leg using a 1/4" (6.4 mm) hex head
socket or adjustable wrench. If the gap between the top of the
door and the underside of the counter top is tight (less than 1/4"
[6 mm]), we suggest side anchoring to keep from scratching the
User Interface or console.
Level legs
Preferred method
38.
Check level side to side and adjust
legs if needed
Place level against top front opening of tub. Check that
dishwasher is level from side to side. If dishwasher is not level,
adjust front legs up or down until dishwasher is level.
Optional method