Connect
to Drain
Place towel under drain hose to catch any water in drain
hose. Place the small green drain hose clamp onto the
small end of the drain hose. Push the new drain hose
into the black drain hose connector
up to the drain hose
stop.
Using pliers, squeeze open the small green drain hose
clamp and slide onto connector
between
stops.
After hose is connected,
remove towel.
If needed, see website for animated
representation
of
this step. Visit www.maytag.com/drain
under FAQ tab.
Make
Direct Wire Electrical
Connection
NOTE: If the power supply
cord was connected
earlier
proceed to "Secure
Dishwasher
in Cabinet
Opening"
section.
Option B, Direct Wire:
Route cable so that it does not touch dishwasher
motor
or lower part of dishwasher
tub. Pull cable through
cable
clamp in terminal
box.
Select UL listed or CSA approved
twist-on wire connectors
(not included)
rated to connect your household wiring to
16-gauge dishwasher
wiring.
18