Fault/Error Codes - Whirlpool Cabrio 5800 Series Service Manual

FOR SERVICE TECHNICIAN ONLY - DO NOT REMOVE OR DESTROY

FAULT/ERROR CODES

The fault codes below would be indicated when attempting to start a drying cycle, or after activating the
service diagnostic mode.
Code
pf
(on some models)
Primary Control Failure
f1 e1
f2 e1
Interface Failure
Exhaust Thermistor Open F3E1 indicates that the thermistor is open.
f3 e1
Exhaust Thermistor Shorted F3E2 indicates that the thermistor has shorted.
f3 e2
Moisture Sensor Open
f3 e6
Moisture Sensor Shorted F3E7 indicates that the moisture sensor strip has
f3 e7
Line Voltage Error
f4e4
Description
Power Failure
Keypad/User
Explanation/Recommended Procedure
PF indicates that a power failure occurred while the
dryer was running.
Press START/PAUSE to continue the cycle, or press
I
POWER or POWER/CANCEL (Maytag models) to clear
the display.
F1E1 indicates a primary control failure.
Replace the machine control electronics. See
I
Accessing & Removing the Electronic Assemblies,
page 23.
F2E1 indicates a stuck button or user interface
mismatch. This fault code will ONLY appear when
in the service diagnostic mode.
See TEST #5, page 22.
I
See TEST #3a, page 19.
I
See TEST #3a, page 19.
I
F3E6 indicates that the moisture sensor strip is open.
This fault code will ONLY appear when in the service
diagnostic mode.
See TEST #4, page 20.
I
shorted. This fault code will ONLY appear when in the
service diagnostic mode.
See TEST #4, page 20.
I
F4E4 indicates low line voltage detected.
Check to see if a household fuse has blown or a
I
circuit breaker has tripped. Confirm the power cord
is properly installed and plugged into the power
outlet. Check the relay connections on the machine
control electronics. Gas Models Only: Check the P14
connection on the machine control electronics.
PAGE 4