Download Print this page

Kenmore 790.3670 Series Use & Care Manual page 43

Slide-in models
Hide thumbs Also See for 790.3670 Series:

Advertisement

Genera[ Care & CReaning (cont'd)
Removing
and Replacing
Warmer
(Warm & Ready
TM)
Drawer
_'_/l_
_
Ebctrbal
Shock Hazard can occur and resuR
in serious injury or death, Disconnect appliance from ebctrb
power before cleaning and servicing the warmer drawer.
To Remove Warmer Drawer:
1,
_Turn
poweroff before removing the warmerdrawer,
2,
Open the drawer to the fully opened position,
3.
Locate glide lever on each side of drawer, pull up on the left glide lever
and push down on the right glide lever (See Figure 1).
5.
Puii the drawer away from the range.
To Replace Warmer (Warm & Ready
TM)
Drawer:
To Replace the Drawer:
1.
Align the glide ends on each side of the drawer with the glide slots on
the range.
2.
Push the drawer into the range until the levers "click" (approximately
3
inches).
3.
Puii the drawer open again to make sure the glides are properly seated.
Note: if you do not hear the levers "click" or the glides do not feel
seated, remove the drawer and repeat steps 1 and 2.
NOTE: The Warmer Drawer wiii NOT operate while in the"Self=Clean" and "Oven
Lockout" modes
Left Glide _
with finger
with finger
Figure
1
Changing
the Oven Light
The oven lights wiii automatically
turn ON when the oven door is opened.
The oven lights may also be manually
operated by pressing
ON/OFF
)ad,
!! . ...........
ii:Z:_
The lamp is covered with a glass shield. The glass shield can be removed to be cleaned manually or to change oven
light. THiS GLASS SHIELD MUST BE iN PLACE WHENEVER
THE OVEN iS iN USE.
To replace
the light bulb:
CAUTION:
BE SURETHE
OVEN iS COOL.
1,
Turn the power off at the main source,
2,
Wear a bather-faced
glove for protection against possible broken glass,
3,
To remove the glass shield, lift up on side with gloved finger and use
force to pull shield out,
4.
Replace halogen light appliance
bulb taking care not to touch the bulb
with your bare fingers. Touching bulb with your skin can leave a film on
the bulb that causes it to burn out quickly.
5.
Replace glass shield in opposite order and manner of removal.
Lift up and pull out.
Halogen
Light Bulb
43

Advertisement

loading

This manual is also suitable for:

790.3671 series