Advertisement
Setting Oven Controls
Setting
the Clock
The CLOCK _
pad is used to set the dock, The dock may be set for 12 or 24 hour
time of day operation,
The dock has been preset at the factory for the 12 hour
operation,
When the range is first plugged in, or when the power supply to the range
has been interrupted, the timer in the display wHI flash with "PF" (power failure, See
Figure 1),
When PF appears in the display, press _'_.
No sound wHI be heard, but after 10 seconds
a beep wHIsounds and PF wHI disappear,
INSTRUCTIONS
To set the clock (example:
1:30)
1,
Press _.
"CLO" wHI appear in the display (Figure 2),
2,
Press
Q Q db pads to set the t ,me day to 1:30
(Figure 3), "CLO" wHI stay in the display, Press s_,
"CLO"
will disappear and the clock will start (Figure 4),
PRESS
Q
qbQQ
Changing
between
12 or 24 hour time of day display
1,
Press and hold _
for 7 seconds (Figure 3), CONTINUE
holding the pad until "12HP' (Figure 4) or "24HP' (Figure 5)
appears in the display,
Press _-_'F_LL_ to switch between the 12 and 24 hour time of
2,
day
display, The display will show either "12Hr" (Figure 4) or "24Hr"
(Figure 5),
3,
Press _A_
to accept the desired change or press _
to
reject the change,
4,
Reset the correct time as described in To set the CJock
above, Please note that if the 24 hour time of day mode was
chosen, the clock will now display time from 0:00 through
23:59 hours,
Q
for 7 seconds
Q
Figure 1
DISPLAY
Figure 2
Figure 3
Figure 4
Figure 5
!! . ...........
iiiljii:_
17
Advertisement
