Advertisement
Setting Surface
Controls
(cont'd)
Setting
the Bridge
Burner
(some models)
The Bridge Burner shouUd be used with rectanguUar shaped cookware,
Cookware Hke the cast-iron Griddb that is supplied with your range is designed
specifically for best resuUts with the Bridge Burner,
The Bridge Burner feature may be used to combine the cooking power of 2 or if
needed 3 gas surface Burners located along the left-hand side of the glass
cooktop, The left rear and left center Burners are controlled by the left rear surface
Control Knob, in addition
the left front Burner may be added to the Bridge Burner
with the left front gas Control Knob (See Figure 1 ),
Operating
the Bridge
Burner
(some modeb)
1,
Push the bft rear surface controU knob in and turn counterclockwise
out of
the OFF position (See Figure 2),
2,
Rebase the knob and rotate to the LITE position (See Figures 2 & 3), Note:
AH eUectronb surface ignitors will spark at the same time, However, only the
selected surface Burner will lite,
3,
Visually check that the left rear Burner has lit,
4,
Continue to rotate the gas control knob clockwise past the first LO setting to
the arrow marked BRIDGE,
5,
Visually check that both the left rear and left center Burners are lit,
6,
When both burners are lit, continue to turn the control knob
counterclockwise
to adjust to the desired flame size for both burners
together, Note: The markings between the 2rid HI and LO settings on the left
rear control knob adjust the flame size for both burners, Use the guide marks
between the 2nd HI and LO settings and adjust the flame size as needed
(Refer to Figure 3),
7,
Add the left front Burner if needed, Once lit, visually adjust the flame size of
the left front Burner to match the flame size of the Bridge Burner,
8,
Place cooking utensil centered over the bft-hand cooktop surface Burner
Grate, DO NOT cook with any of the surface control knobs in the LFE
position (The electronic ignitor will continue to spark if the knob is left in the
MTE position),
Note: If only the left rear surface Burner is needed, follow the instructions
provided below,
Figure 1
Operating
only
the
Left rear
Gas Surface
Burner
(some models)
1,
Place cooking utensil centered over the left-rear surface Burner Grate,
2,
Push the left rear surface control knob in and turn counterclockwise
out of
the OFF position (See Figure 2),
3,
Release the knob and rotate to the LITE position, Note: All electronic surface
ignitors will spark at the same time, However, only the left rear Burner will
ignite,
4,
Visually check that the left-rear burner has lit, Adjust the
flame size by turning the control knob between the first HI
and LO settings
(See Figure 3), DO NOT cook with the
surface control knob in the LITE position (The electronic
ignitor will continue to spark if the knob is left in the LITE
position),
Left Rear Burner
flame adiustment
area
12
Figure 2
OFF
Bridge Burner--
8_'Jae_
LITE position
Figure 3
/
I
Lo
L_
Bridge Burner
flame adiustment
area
Advertisement
