Connecting The 82357B To Your Pc - Keysight 82357B User Manual

1 Installing the Keysight 82357B

Connecting the 82357B to your PC

This section shows steps to connect the 82357B to a USB port on your PC or to
your PC via a USB Hub.
1 Connect to a USB Port. Make sure the PC is ON and plug the 82357B USB
Figure 1-4
2 Observe the LEDs. Observe the LEDs on the 82357B for at least 10 seconds.
20
cable into any available USB port on your PC. Do not connect the 82357B to
GPIB instruments at this time.
Connecting the 82357B to Your PC
See Chapter 2, "Using the Keysight 82357B"
LED sequence during an initial installation of the 82357B.
a Initially, only the red FAIL LED should be ON. After a few seconds, all three
LEDs should be ON. When all three LEDs are ON, this shows that the
82357B has been successfully installed.
b If all three LEDs are not ON after 10 seconds and all Windows
Plug-and-Play Manager activity has ceased, STOP. See
"Troubleshooting the Keysight 82357B"
for a description of the normal
Chapter 3,
for diagnostics information.
Keysight 82357B User's Guide