Sun Microsystems Ultra 1 Series Upgrade Manual page 27

2
6. Replace the EMI door.
Note – The EMI door must be flush with the chassis or the top cover will not fit
correctly.
a. Position the EMI door on the chassis. The two tabs should be hooked
into the two slots (Figure 2-9).
b. Push the door in until it is flush with the chassis
Chassis
EMI door
Figure 2-9 Replacing the EMI Door
7. Install the disk drive in the Sun Ultra 30 system.
Refer to the Sun Ultra 30 Installation Guide for installation instructions.
Removing Ultra 1 Series Internal Components 17