2
16
2. Locate the disk drive(s) that you want to remove (Figure 2-8).
Check the disk drive part number to select which drives may be transferred
to the Sun Ultra 30 System.
Note – The disk drive part number is affixed to the front of the diskdrive
handle.
The disk drives supported by the Sun Ultra 30 System have part numbers
540-2936-xx and 540-2938-xx. No other internal disk drives supported on the
Sun Ultra 1 Series may be transferred to the Sun Ultra 30 System.
3. Unlatch the drive handle and swing it open (Figure 2-8).
Move the drive latch to the right to unlock the drive handle.
Note – The drive rear connector is disconnected when disk drive is removed.
Drive handle
Drive latch
Figure 2-8
Removing the Disk Drive
4. Hold the drive handle and pull it out to remove the drive from the chassis
(Figure 2-8).
5. Place the drive on an antistatic surface.
Sun Ultra 1 Series to Sun Ultra 30 System Upgrade Guide—June 1997