Onboard Devices Configuration - Asus PRIME TRX40-PRO Manual

The following items appear only when SATA Port Enable is set to [Enabled].
SATA Mode
This item allows you to set the SATA configuration.
[AHCI] Set to [AHCI] when you want the SATA hard disk drives to use the
AHCI (Advanced Host Controller Interface). The AHCI allows the
onboard storage driver to enable advanced SATA features that
increases storage performance on random workloads by allowing
the drive to internally optimize the order of commands.
[RAID] Set to [RAID] when you want to create a RAID configuration from
the SATA hard disk drives.
NVMe RAID Mode
This item allows you to enable or disable the NVMe RAID mode.
Configuration options: [Disabled] [Enabled]
SMART Self Test
S.M.A.R.T. (Self-Monitoring, Analysis and Reporting Technology) is a monitoring system
that shows a warning message during POST (Power-on Self Test) when an error occurs in
the hard disks.
Configuration options: [On] [Off]
SATA6G_1(Gray) - SATA6G_8(Gray)
SATA6G_1(Gray) - SATA6G_8(Gray)
This item allows you to enable or disable the selected SATA port.
Configuration options: [Disabled] [Enabled]
Hot Plug
These items appears only when the SATA Mode is set to [AHCI] and allows you to
enable or disable SATA Hot Plug Support.
Configuration options: [Disabled] [Enabled]
M.2_3(Gray)
M.2_3(Gray)
This item allows you to rename the AMD APU M.2 ports.
3.6.8

Onboard Devices Configuration

The items in this menu allow you to switch between PCIe Lanes and configure onboard
devices.
PRIME TRX40-PRO
3-15