Table of Contents
Advertisement
3.6.4
USB Configuration
The items in this menu allow you to change the USB-related features.
The Mass Storage Devices item shows the auto-detected values. If no USB device is
detected, the item shows None.
Legacy USB Support
[Enabled]
[Disabled]
[Auto]
XHCI Hand-off
[Enabled]
[Disabled]
USB Single Port Control
This item allows you to enable or disable the individual USB ports.
Refer to section Motherboard layout for the location of the USB ports.
3.6.5
HDD/SSD SMART Information
This menu displays the SMART information of the connected devices.
NVM Express devices do not support SMART information.
3.6.6
NVMe Configuration
You may view the NVMe controller and Drive information if an NVMe device is connected.
3.6.7
SATA Configuration
While entering Setup, the BIOS automatically detects the presence of SATA devices. The
SATA Port items show Not Present if no SATA device is installed to the corresponding
SATA port.
SATA Port Enable
This item allows you to enable or disable the SATA Device.
Configuration options: [Disabled] [Enabled]
3-14
Your system supports the USB devices in legacy operating systems.
Your USB devices can be used for BIOS setup only and cannot be
recognized in the boot devices list.
Your system automatically detects the presence of USB devices at startup.
If any USB devices are detected, the legacy USB support is enabled.
Enables the support for operating systems without an XHCI hand-off
feature.
Disables the XHCI Hand-off support.
Chapter 3: BIOS Setup
Hide quick links:
Advertisement
Table of Contents
