Repair Instructions; To Assemble The Tube And Handle On The Product - Husqvarna 340iBT Workshop Manual

5.1 To assemble the tube and handle on the
product
1. Put the clamp (A) on the flexible tube (B) and push
the flexible tube onto the blower outlet (C).
A
C
2. Put the screw (D) on the clamp below the tube and
tighten the screw.
3. Attach the transport strap (E) to the guide track of
the joint swivel (F).
E
4. Put the clamp (G) on the flexible tube (B) and attach
the joint swivel (F).
G
B
5. Put the screw (H) on the clamp below the tube and
tighten the screw.

12 - Repair instructions

5 Repair instructions
6. Align the knobs (I) to each side of the joint swivel
B
D
7. Attach the operation handle (J) to the guide track (K)
8. Tighten the screw on the operation handle fully.
9. Connect the intermediate pipe (L) to the joint swivel
F
F
10. Turn the intermediate pipe (L) fully to lock the joint
11. Connect the blow pipe (M) to the intermediate pipe
H
12. Turn the blow pipe fully to lock the intermediate pipe
(F).
K
I
F
of the joint swivel (F). Make sure that the screw on
the operation handle is on the bottom side of the
control pipe.
(F). Make sure that the knob (I) aligns with the guide
track of the intermediate pipe.
N
L
F
I
swivel (F) and the intermediate pipe.
(L). Make sure that the knob (N) on the intermediate
pipe points up and goes into the guide track of the
blow pipe.
and the blow pipe.
J
M
1126 - 001 - 08.11.2019