SuperDroid Robots MLT-JR Assembly And Operation Manual page 3

It is always important to use safe practices. Only people with good mechanical and electrical experience should
work on the robots. Minors should always be supervised by adults.
The aluminum chassis also has many sharp edges and care needs to be taken not to get cut. Sharp edges can
be brought down with a metal file.
The treaded ATRs have very powerful motors. The treaded design presents many pinch points! If fingers
or hands are inside the treaded section and the motors energize, you cause serious injury. ALWAYS disconnect
the power before working on the robot. The easiest way of disconnecting the power is by pulling the motor
fuse(s). Do not solely rely on the switch as a disconnect, since it can be easily bumped and turned on resulting
in the motors surging.
SuperDroid Robots, Inc
224 Technology Park Lane
Fuquay Varina, NC 27526
www.SuperDroidRobots.com
Revised: May 22, 2018
MLT-JR Tracked Robot Platform
Contact
(919) 557-9162
SDR@SDRobots.com
Page 3 of 13