Insert the other end of the PR27-30F or PSH32-30F cable into the CB-27 connector. The cable connector is keyed with a centered tab that you must align with the slot on the CB-27 mating header. Firmly push in the cable connector until the ejector ears on the CB-27 connector snap into position.
CB-27. You can fill in the blanks with the signal information from your DAQCard user manual and put the label on the inside of the CB-27 cover for easy reference. (Your DAQCard kit also contains a completed quick-reference label.)
Page 4
After you connect the wires to the screw terminals, attach the wires to the CB-27. Bunch the wires from one side of the connector block and tie them to a strain-relief tab using a tie wrap (see Figure 2b). Repeat for the other side of the connector block.