luminii Katana KAT Installation Instructions

Katana - Installation Instructions
Model KAT-
Please read all instructions prior to installation and keep for future reference!
1. PRODUCT TO BE INSTALLED BY A
QUALIFIED ELECTRICIAN
2. USE ONLY WITH CLASS 2 POWER UNIT
3. 24 VOLTS DC
4. SUITABLE FOR DAMP LOCATIONS
1
0.70"
2.06"
Use the dimensions above for reference, when mounting to the
surface.
3
Remove the protective film from the diffuser lens.
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATIONS & INSTRUCTIONS WITHOUT NOTICE
5. SURFACE MOUNT ONLY
6. SUITABLE FOR INSTALLATION WITHIN THE
CLOSET STORAGE SPACE
7. TYPE IC
8. INHERENTLY PROTECTED
Katana light fixture body
0.66" 0.70"
lens
film
2
0.31"
Align the fixture to the determine location,
(low voltage power wires must be present prior to
installing). Secure by tightening the two screw
through the mounting brackets to the drywall.
4
24VDC class II
power supply
120VAC line
voltage wires
Ensure power is off to power supply!
Then proceed to connect wires from Katana light fixture to
power supply. Connection can be established with lead wires or
quick-connect powerfeed. For more information please refer to
power supply wiring instructions.
7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
info@luminii.com
Page 1 of 2
www.luminii.com
mounting
brackets
mounting
screws
power to Katana
light fixture
24VDC low
voltage wires
wires to
power
supply
REV2.4