3.5 inch embedded single board computer with intel atom x7-e3950,
2 gige lan w/ieee 1588, isolated com,
tpm 2.0, -40 degrees celsius to 85 degrees celsius (68 pages)
Page 3
This manual is released by Vecow Co., Ltd. for reference purpose only. All product offerings and specifications are subject to change without prior notice. It does not represent commitment of Vecow Co., Ltd. Vecow shall not be liable for direct, indirect, special, incidental, or consequential damages arising out of the use of the product or documentation or any infringements upon the rights of third parties, which may result from such use.
Page 4
Order Information Part Number Description ® ® ® UMBC-1100 MicroATX Motherboard, Intel C246 with Intel Xeon UMBC-1100 Core™ i7/i5/i3 Processor (CFL-R S/CFL-S), 4 GigE LAN, 6 USB 3.1, 4 COM, 8 SATA III, 1 M.2, 1 PCIe x16, 2 PCIe x4, 16 GPIO...
SATA III, 6 USB 3.1, 4 USB 2.0, 16 GPIO; 1 PCIe x16, 2 PCIe x4, and 1 M.2 expansion; iAMT 12.0, TPM 2.0, Wake on LAN and PXE smart manageability, Vecow ECX-1000 Series 5,25" SBC serves compact & flexible solutions to meet your project requirements.
USB, RJ45,HDMI,Display Port, and any VGA, are placed on the front panel. 2.2.1 Audio Connector There are two audio connectors, mic-in and line-out, on the front side of UMBC-1100. Onboard Realtek ALC892 audio codec supports 5.1 channel HD audio and fully ®...
Page 16
There are 4 USB 3.1 Gen1 connections available supporting up to 5GB per second data rate in the top side of UMBC-1100. They are also compliant with the requirements of SuperSpeed (SS), high speed (HS), full speed (FS) and low speed (LS).
Page 17
Onboard HDMI Port supports DDC channel mode. The connection supports up to 4096x2160 @24Hz. 2.2.5 DISPLAY PORT UMBC-1100 supports single Display Port and up to 4096 x 2304 pixels resolution. 2.2.6 VGA UMBC-1100 supports single VGA and up to 1920 x 1200 pixels resolution.
Page 21
2.2.6 JUSB1, JUSB2 : Internal USB 2.0 The UMBC-1100 main board provides maxima eight expansion USB ports. The USB interface supports 480Mbps transfer rate which comply with high speed USB specification Rev. 2.0. The USB interface is accessed through one 10-pin JST 1.0mm connector. You will need an adapter cable if you use a standard USB connector.
Page 22
2.2.7 JUSB3 : Internal USB 3.1 There are 2 USB 3.1 connections available supporting up to 5GB per second data rate in the top side of UMBC-1100. They are also compliant with the requirements of SuperSpeed (SS), high speed (HS), full speed (FS) and low speed (LS).
2.3 Jumper Settings 2.3.1 Front View of UMBC-1100 Main Board With Jumper Location JCOMS1 You may configure your card to match the needs of your application by setting jumpers. A jumper is a metal bridge used to close an electric circuit. It consists of two metal pins and a small metal clip (often protected by a plastic cover) that slides over the pins to connect them.