3.5 inch embedded single board computer with intel atom x7-e3950,
2 gige lan w/ieee 1588, isolated com,
tpm 2.0, -40 degrees celsius to 85 degrees celsius (68 pages)
This manual is released by Vecow Co., Ltd. for reference purpose only. All product offerings and specifications are subject to change without prior notice. It does not represent commitment of Vecow Co., Ltd. Vecow shall not be liable for direct, indirect, special, incidental, or consequential damages arising out of the use of the product or documentation or any infringements upon the rights of third parties, which may result from such use.
Page 4
Order Information Part Number Description ® EXBC-1000 5.25" Embedded Single Board Computer, Intel H310 ® EXBC-1000 with Intel Core™ i7/i5/i3 Processor (CFL-R S/CFL-S), 4 GigE LAN, 4 USB 3.1, 4 COM, 1 PCIe, 2 Mini PCIe, 16 GPIO EXBC-1000 5.25" Embedded Single Board Computer, Intel ®...
1.5.2 Dimensions of Heat Spreader 1.5.3 Dimensions of Heat Sink 1.5.4 Dimensions of Fan Bracket 1.5.5 Dimensions of EXBC-1000 Series + Heat Spreader 1.5.6 Dimensions of EXBC-1000 Series + Heat Sink 1.5.7 Dimensions of EXBC-1000 Series + Fan Sink CHAPTER 2 GETTING TO KNOW YOUR EXBC-1000 2.1 Packing List...
DDR4 2666MHz up to 64GB ECC memory, advanced Intel Graphics 630 supporting DirectX 12, OpenGL 4.5, OpenCL 2.0 API, and up to Ultra HD 4K resolution, Vecow EXBC-1000 5.25" SBC delivers leading CPU & chipset performance, power efficiency, and graphics performance; Multiple 10G SuperSpeed USB 3.1 Gen 2 (10Gbps), PCIe 3.0 (8GT/s), SATA III (6Gbps),...
1.5 Mechanical Dimension 1.5.1 Dimensions of EXBC-1000 Series 203.0 (7.99”) 102.4 (4.03”) 85.8 (3.38”) 102.4 (4.03”) 85.7 (3.38”) Unit : mm (inch) 1.5.2 Dimensions of Heat Spreader Unit : mm (inch) 206.5 (8.13”) 9.0 (0.35”) 120.0 (4.72”) 1.5.3 Dimensions of Heat Sink Unit : mm (inch) 206.5 (8.13”)
Page 22
Ground 2.2.3 BAT1 : RTC Battery The EXBC-1000's real-time clock is powered by a lithium battery. It is equipped with Panasonic BR2032 190mAh lithium battery. It is recommended that you not replace the lithium battery on your own, but if the battery needs to be changed, please contact the Vecow RMA service team.
Page 23
Description PWR_BTN_P 2.2.5 JUSB1 : Internal USB 2.0 Connector The EXBC-1000 main board provides maxima eight expansion USB ports. The USB interface supports 480Mbps transfer rate which comply with high speed USB specification Rev. 2.0. The USB interface is accessed through one 10-pin JST 1.0mm connector. You will need an adapter cable if you use a standard USB connector.
Page 28
There are 4 USB 3.1 Gen2 connections available supporting up to 10GB per second data rate in the front side of EXBC-1000. It also compliant with the requirements of Super Speed (SS), high speed (HS), full speed (FS) and low speed (LS).
Page 29
Yellow Yellow Yellow 2.2.12 LVDS1, J6 : LVDS LVDS1 EXBC-1000 supports dual-channel 24-bit LVDS display and up to 1920 x 1200 pixels resolution. The pin assignments of LVDS are listed in the following table : Pin No. Definition Pin No.
Page 31
SATA2 SATA1 There are 2 onboard high performance Serial ATA III (SATA III) on EXBC-1000. It supports higher storage capacity with less cabling effort and smaller required space. The pin assignments of SATA1 and SATA2 are listed in the following table : Pin No.
2.3 Jumper Settings 2.3.1 Front View of EXBC-1000 Main Board With Jumper Location JCOMS1 JP10 JP12 JP11 You may configure your card to match the needs of your application by setting jumpers. A jumper is a metal bridge used to close an electric circuit. It consists of two metal pins and a small metal clip (often protected by a plastic cover) that slides over the pins to connect them.
APPENDIX A : GPIO GUIDE A.1 Function Description The EXBC-1000 offers a 16-bit GPIO a pair of 20-bit internal connector, and a watchdog timer. GPIO definition is shown below : Pin No. GPIO Definition Pin No. GPIO Definition GPIO0 GPIO8...