Error Message - Panasonic CF-20 Series Operating Instructions And Reference Manual

Error Message

Follow the instructions below when an error message appears. If the problem persists or if the error message is not shown here, contact Panasonic Tech-
nical Support.
Error Message
Bad System CMOS
System CMOS Checksum Error
Invalid Year. System date restored to 01/01/20XX
Press F2 for Setup / F12 for LAN
Reboot and Select proper Boot device or Insert Boot
Media in selected Boot device and press a key
Disk error Press any key to restart
An error has occurred in the memory of system settings. This occurs when the memory
content is changed by an unexpected program operation, etc.
Start the Setup Utility and return the settings to the default values, and then
change the settings as necessary.
If the problem persists, the internal clock battery may need to be replaced.
Contact Panasonic Technical Support.
The date and time settings are not correct.
Start the Setup Utility and set the correct date and time.
If the problem persists, the internal clock battery may need to be replaced.
Contact Panasonic Technical Support.
Write down the error details and press ≪ F2≫ or ≪ Del≫ to start the Setup
Utility.
Change the settings if necessary.
The operating system is not properly installed in the flash memory that you are going to
boot from.
If you cannot start up the OS from the internal disk, check if the internal disk is
properly recognized on the "Information" menu of the Setup Utility.
If it is recognized ("xxx GB" is displayed.), perform the reinstallation.
If not ("Empty" is displayed.), contact Panasonic Technical Support.
If a device is connected to the USB port, remove the device, or set [Legacy USB
Support] to [Disabled] on the "Advanced" menu of the Setup Utility.
Solution