Panasonic CF-20 Series Operating Instructions And Reference Manual page 151

Running the Diagnostic Check
Run this utility using the default settings in the Setup Utility.
If the Setup Utility or other settings will not allow hardware to be executed, the hardware icon will be displayed in gray.
1. Connect the AC adaptor, and be enabled the wireless function.
During the diagnostic check, do not remove the AC adaptor, or attach any peripheral devices.
2. Start the Setup Utility.
1. Click (Start) -
Alternatively, click
2. Click [Restart now] under "Advanced startup"
3. Click [Troubleshoot] - [Advanced options] - [UEFI Firmware Settings] - [Restart].
The computer restarts, and the Setup Utility screen appears.
If the password is requested, enter the Supervisor Password.
If you are using the computer after changing the settings from the status at the time of purchase, we recommend that you make a note
of the settings that are changed.
*2 : Screen messages are explained in [English (United States)].
(Depending on the language preference, some screen messages in these instructions are different from the actual screen messages. For
example, [Advanced start-up] may be displayed instead of [Advanced startup] in some language preference.)
3. Press ≪ F9≫ .
At the confirmation message, select [Yes] and press ≪ Enter≫ .
4. Press ≪ F10≫ .
At the confirmation message, select [Yes] and press ≪ Enter≫ .
The computer will restart.
5. Press ≪ F2≫ to display Setup Utility.
6. Select the [Exit] menu, then select [Diagnostic Utility].
When the PC-Diagnostic Utility starts up, it will automatically begin the diagnostic check for all hardware components.
If the password is requested, enter the password.
The touchpad and the internal keyboard may not be used when each hardware checking is running. While checking, vertical green pro-
gress bar is displayed on the right side of the hardware icon (A).
By clicking the icon, you can execute the following operations:
You can check the status of the diagnostic check by the display on the right side of the hardware icon (A).
None: Not running diagnostic check
Vertical green progress bar: Currently running diagnostic check.
During memory diagnostic check, the display may stop for a long period of time. Wait until the process is complete.
Green: No problems discovered
Red: Problems discovered
N O T E
Using the following procedure, you can run a diagnostic check on a specified hardware component, or run an extended
n
(Settings) - [Update & Security] - [Recovery].
(Settings) - [Update & Security] - [Recovery] in the tablet mode.
: Start the diagnostic check from the beginning
: Stop the diagnostic check (You cannot restart the check partway through by clicking
: Display help (click the screen or press ≪ Space≫ to return to the original diagnostic check screen)
*2
.
)