Page 1
Page 2
Page 3
Page 4
8 / 12
The following parameters can be set separately for all displays:
Warning Time:
here you can set for each display if and how long
the alarm should be active for a specific value.
Repeat Time:
here you can set how often an alarm should be
active when a specific value is reached.
Signal Tone:
sets the signal tone melody. The warning sounds are
combined with the warnings on the display and the voice out-
put. Therefore, they may not be changed.
Save Sensor: yes/no
After every setting in the pages "Page 1 - 5" the data must be
transferred to the PDB + SBEC Module. Select "yes" and push
"Enter". If you do not proceed as described, the new data will
not be saved.
Factory set
A factory reset will be done if you select "yes" and push "Enter".
Min Power Voltage
Here you can set the alarm threshold for minimum voltage.
The alarm threshold can be set between 0 and 25.0 V in steps
of 0,1 V.
Factory setting: 11.0 V, Signal Tone: P
Sensor 1 Voltage
Here you can set the first alarm threshold for voltage.
The alarm threshold can be set between 0 and 25.0 V in steps
of 0,1 V.
Factory setting: 10.8 V, Signal Tone: R
Sensor 2 Voltage
Here you can set a second alarm threshold for voltage.
The alarm threshold can be set between 0 and 25.0 V in steps
of 0,1 V.
Factory setting: 10.5 V, Signal Tone: S
S8474_PDB_SBEC_V_1_jh