Removing A Blade Server Cover - Cisco UCS B460 M4 Installation And Service Note

Blade server

Hide thumbs Also See for UCS B460 M4:

Table of Contents

Servicing the Blade Server

Figure 8: Removing and Installing a Drive

Step 2

Gently slide the hard drive into the opening in the blade server until it seats into place and the latch fully

engages.

Step 3

Push the hard drive lever into the closed position.

You can use Cisco UCS Manager to format and configure RAID services. See the UCS Manager configuration

guide for your software release for details on RAID configuration.

If you need to move a RAID cluster from one server to another, refer to the "Moving a RAID Cluster" section

of the "Troubleshooting Server Hardware" chapter of the Cisco UCS Troubleshooting Guide.

Removing a Blade Server Cover

Procedure

Step 1

Press and hold the button down as shown in the figure below.

Cisco UCS B260 M4 and B460 M4 Blade Server Installation and Service Note for Servers with E7 v3 and E7 v2 CPUs

Table of Contents

Ucs b260 m4