Cisco UCS B460 M4 Installation And Service Note page 18

Installing a Blade Server in the Chassis
Figure 5: Removing a Slot Divider
Tip
Step 2 Grasp the front of the blade module and place your other hand under the blade to support it.
Figure 6: Positioning a UCS B260 M4 Blade Module in the Chassis
Step 3 Open the ejector levers in the front of the blade module.
Step 4
Gently slide the blade into the blade slot opening until you cannot push it any farther.
Step 5 Press the ejector levers so that they latch with the edge of the chassis and press the blade module all the way
in.
Step 6
Tighten the captive screw on the front of the blade to no more than 3 in-lbs. Tightening with bare fingers will
prevent stripped or damaged captive screws.
Step 7
Attach the UCS Scalability Terminator or UCS Scalability Connector to the blade module(s) as follows:
Cisco UCS B260 M4 and B460 M4 Blade Server Installation and Service Note for Servers with E7 v3 and E7 v2 CPUs
10
To reinstall the slot divider, align it with the dimples in the slot top and bottom and slide it back
in until it clicks into place.
Installing a Blade Server