Removing A Blade Server Cover - Cisco UCS B440 Installation And Service Note

Removing a Blade Server Cover

S e n d d o c u m e n t c o m m e n t s t o u c s - d o c f e e d b a c k @ c i s c o . c o m
Tighten the captive screw on the front of the blade to no more than 3 in-lbs. Tightening with bare fingers
Step 6
only is unlikely to lead to stripped or damaged captive screws.
Removing a Blade Server Cover
To open a blade server, follow these steps:
Press and hold the button down as shown in callout 1 of
Step 1
Step 2 While holding the back end of the cover, pull the cover back and upas shown in callout 2 of
Figure 6
Cisco UCS B440 High Performance Blade Server Installation and Service Note
16
Opening a Blade Server
1
Figure 6.
2
Figure 6.
OL-22475-01