LG ACP IV Install/Owner’s Manual page 14

INSTALLING ACP IV
14
Turning on the ACP IV
Turn on the ACP IV to set the network environment of the ACP IV.
When the power switch is turned on, the ACP IV booting screen is displayed on the LCD as
shown at the following figure, and when booting is completed, the initial ACP IV screen is dis-
played.
Wait for booting···
!
NOTE
Software version
The software version of the current ACP IV is displayed at the
initial ACP IV screen.
Also, the software version may be different according to the
manufacturing date of the ACP IV.
Entering into the environment setup mode
Press [SET] button of the ACP IV to enter into the environment setup mode of the ACP IV.
When the [SET] button is pressed for the first time, the menu to set the IP address is displayed
as shown below.
Press up/down(▲, ▼) button to place the arrow on the desired function.
• When you select [Network Info] and press [SET] button, it enters the No. 1 menu in the follow-
ing figure. In [Network Info] menu, input the network information such as IP address of the
ACP IV.
• When you select [Function] and press [SET] button, it enters the No. 2 menu in the following
figure. In [Function] menu, ACP IV software service function is supported.
LG ACP IV
SW ver. 1.0.0
IP 192.168.001.100
GW 192.168.001.001
! CAUTION
• [Function] menu is used by the system air conditioner service technician, so user shallnev-
er use this function.
• If this function is incorrectly used, it may cause disorder of the ACP IV.
LG Electronics
> Network Info
Function
[ S E ] T
> Network Info
Function
[ ]
LG ACP IV
SW ver. 1.0.0
IP 192.168.001.100
GW 192.168.001.001
LG ACP IV
SW ver. 1.0.0
IP 192.168.001.100
GW 192.168.001.001
1
[ Network Info ]
IP 000.000.000.000
GW 000.000.000.000
MS 000.000.000.000
[ S E ] T
MC 000000:00:00:00
DHCP NO
2
[ Function ]
S/W update
[ ]
DB back up
DB recover
Data Logging
ACP_ID(DEMAND)
Language
Net Test