Zcom AS220V2 Quick Start Manual page 6

AS220V2
following optional settings.
Optional: Set up the access point by your computer
Note: The following procedure assumes that Windows 10 is the operating system.
Procedures for other operating systems are similar.
Step 1. On your computer, configure your network adapter from the
settings as follows:
˙ StartControl PanelNetwork and Sharing CenterChange Adapter Settings
Step 2. Edit the TCP/IPv4 address setting as follows:
˙ Local Area ConnectionPropertiesInternet Protocol Version 4(TCP/IPv4)
Properties
Note: Record all of the currently active settings so you can restore your computer to its
current configuration later (when this process is complete.)
Step 3. Select Use the following IP address
"
˙ IP address: 192.168.1.168 (or any available address in the 192.168.1.x network, except
192.168.1.1)
˙ Subnet mask: 255.255.255.0
Leave the "Default gateway" and "DNS server" fields empty.
Step 4. Click "OK" to save your changes.
Login into the access point
Step 1. Launch a Web browser; type 192.168.1.1 URL to connect to the access point. When a
security alert dialog box appears, click OK/Yes to proceed.
Step 2. When login page appears, enter the following: Username: root/Password: password
Step 3. Click login.
Customizing the Wireless Settings
On the Web interface menu, Select StatusGeneral in the menu bar. Check your switchmod item
to select "Connect with via IP", and setup your WLC IP address on "Wireless Switch Address 1".
Note: In TAP mode, the access point must be able to go with WLCs for bulk configuration
and performing other commands of access points. Please refer to WLC QSG for more
information. https://www.zcom.com.tw/index/downloads
Note: If you need a standalone access point, please refer to the FAP mode configuration.
2x2 Dual Band 802.11ac Wave 2 Indoor Access Point
and make the following entries:
"
Local Area Connection"
"
QSG
5