Blower Operation - Vacmaster VDK1430SFC Original Instructions Manual

2) Optionally, fully fit the dust bag flange onto the inlet stub. The vacuum cleaner can we be used
with or without dust bags.
IMPORTANT: Check the filter regularly for optimal performance. An old or blocked filter will reduce
suction performance.
For Wet Vacuuming:
1) To prepare your vacuum cleaner for wet vacuuming, release the retainer lock and remove the
dry use cartridge filter.
2) Carefully install the supplied foam filter over the internal filter cage, making sure the whole cage
is covered (Fig. 14).
WARNING:
DO NOT USE THE CARTRIDGE FILTER FOR WET VACUUMING.
DO NOT USE A DUST COLLECTION BAG FOR WET VACUUMING.
IMPORTANT! When vacuuming large quantities of liquids, do not immerse the nozzle completely;
leave a gap at the tip of the nozzle to allow air inflow. The machine is fitted with a float valve that
stops the suction action when the container reaches its maximum capacity. You will notice an
increase in motor noise. When this happens, turn off the machine, disconnect from power supply,
and drain the liquid using the drainage hose. Ensure the drainage cap is re-installed before
continuing to vacuum.

6. Blower Operation

WARNING:
WARNING:
USE THE BLOWER FUNCTION IN AN ENCLOUSED SPACE OR FOR DUSTS
WHICH ARE HAZARDOUS TO HEALTH. DO NOT INHALE DUSTS. DO WEAR
A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE INHALED.
WARNING:
REMOVING DUST, OR DRYING MACHINES AND APPLIANCES.
1) Make sure the container and any collected waste is emptied before using as a blower. This also
includes removal of the dust bag.
2) Insert the locking end of the hose into the blowing port on the side of the power head (Fig. 15).
3) Turn on the motor on by turning the switch to the 'I' ON position.
KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
ONLY WORK WITH A CLEAN SUCTION HOSE. DO NOT
ONLY USE THE BLOWING FUNCTION FOR CLEANING,
13
GB