Replacing A Turn Signal Light Bulb; Supporting The Motorcycle - Yamaha MTM155 Owner's Manual

Periodic maintenance and adjustment
Replacing a turn signal light
bulb
1. Remove the turn signal light lens
by removing the screw.
1. Screw
7
2. Remove the burnt-out bulb by
pushing it in and turning it coun-
terclockwise.
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screw. NOTICE: Do not over-
tighten the screw, otherwise the
lens may break.
EAU24205

Supporting the motorcycle

Since this model is not equipped with a
centerstand, follow these precautions
when removing the front and rear
wheel or performing other mainte-
nance requiring the motorcycle to
stand upright. Check that the motorcy-
cle is in a stable and level position be-
fore starting any maintenance. A
strong wooden box can be placed un-
der the engine for added stability.
1
To service the front wheel
1. Stabilize the rear of the motorcy-
cle by using a motorcycle stand
or, if an additional motorcycle
stand is not available, by placing a
jack under the frame in front of the
rear wheel.
2. Raise the front wheel off the
ground by using a motorcycle
stand.
To service the rear wheel
Raise the rear wheel off the ground by
[ECA11192]
using a motorcycle stand or, if a motor-
cycle stand is not available, by placing
EAU24351 a jack either under each side of the
frame in front of the rear wheel or under
each side of the swingarm.
7-32