Switching On The Neckband Speaker And Connecting Via Bluetooth; Switching On The Neckband Speaker; Connecting The Neckband Speaker Via Bluetooth - Silvercrest SNL 15 A1 Operating Instructions Manual

7. Switching on the neckband
speaker and connecting via
Bluetooth
7.1.

Switching on the neckband speaker

 Press and hold the
speaker is switched on and an acoustic signal sounds.
The neckband speaker switches on with an acoustic signal and the op-
erating LED starts flashing red rapidly.
7.2. Connecting the neckband speaker via
Bluetooth
Using Bluetooth, you can receive audio signals wirelessly from an exter-
nal Bluetooth-enabled audio playback device. Please note that the two
devices may not more be than 10 metres apart.
You can only connect one Bluetooth device to the neckband
speaker.
 If you have not already done so, switch on the neckband speaker.
 Enable Bluetooth
tooth device SNL 15 A1.
 Now pair and connect your Bluetooth-enabled playback device to
the neckband speaker.
The operating LED stops flashing as soon as an audio playback device
is paired with the neckband speaker.
After switching on, the neckband speaker will search for the audio play-
back device last connected. If possible, the neckband speaker will auto-
matically restore this connection.
The operating LED flashes white rapidly.
Once the speaker is paired, the LED lights up white.
®
button for about 3 seconds until the neckband
®
® on your audio playback device and select Blue-
English – 17