Advertisement
2. Open the cap of the Detergent Tank (14) and add the detergent into the tank if
required for cleaning.
3. Plug in the appliance to a grounded outlet.
4. When you switch the appliance on, the indicator lights will turn red on each side of the
water tank, indicating preheating. If the lights do not illuminate, please check the
"troubleshooting" section for more details.
5. It will take approximately 20 seconds for preheating to complete. Once the steam mop
is ready to use, the water tank will glow blue, and the mop will emit the steam
automatically.
•
Notice: If you power off during preheating or after preheating, then power on
again and the appliance will repeat the above preheating action.
6. When the cleaning surface is stained with grease or oil, etc., you need to press the
on/off switch (15) to the ON position, then the detergent will emit together with the
steam.
7. When the water tank is empty, fill with water and it can work for approximately 20
minutes.
8. Control the steam volume by turning the steam control knob (10) clockwise to increase
and anticlockwise to reduce.
•
Notice: Steam volume control via the knob will take 3 seconds from when you
adjust steam volume to when it releases steam at this volume. This is a normal
phenomenon.
9. When normal cleaning, the steam head has big rotary angle, it can clean corners and
can clean low spaces.
9
Advertisement
