Repeat this step and connect Flame Screen (B) to other 3 sets of upper Support Bars. (See Figure Ⅲ, Ⅳ)
STEP 6: Unscrew 8 M5 Screws and Washers (BB) preassembled on top of tank housing assembly (K).
Place the lower Support Bars to the top of the tank housing assembly. Make sure to match the top ends of
the tank housing assembly with the slot of the lower Support Bar. Match the threaded hole and fix each
connection with 2 M5 Screws and Washers (BB)
STEP 5: Place Reflector (A) on the Flame Screen (B)
and fix the connection using 4 M5 CAP NUTS (AA).
-
6
-