Table of Contents
Advertisement
Lubrication
Lubricating the Drive-roller
Bearings and the Steering
Heads
Service Interval: Before each use or daily (lubricate
immediately after every washing).
Grease Type: # 2 general-purpose lithium-based grease
1. Wipe each area clean so that foreign matter cannot be
forced into the bearing or bushing.
2. Pump grease into the areas as shown in Figure 10 and
Figure 11.
1
Figure 10
1. Drive roller
3. Wipe up any excess grease.
Important: After greasing, run the machine off
the turf somewhere briefly to disperse any excess
lubricant, to avoid damaging the turf.
G0242 00
Figure 11
Lubricating the Linkage Pivot
Points
Service Interval: Before each use or daily
Apply a few drops of SAE 30 engine oil or spray lubricant to
all the pivot points after cleaning the machine.
Important: After oiling, run the machine off the turf
somewhere briefly to disperse any excess lubricant, to
avoid damaging the turf.
Lubricating the Drive Chain
Service Interval: Before each use or daily
Lightly lubricate the drive chain with Drislide® multipurpose
lubricant or an equivalent lubricant.
G0240 12
18
Advertisement
Table of Contents
