Draining And Refilling - Sundance Spas 880 Series Owner's Manual

Hide thumbs Also See for 880 Series:
Table of Contents

Advertisement

Available languages

Available languages

3. Slowly and gently tilt the panel forward to
remove. This will expose the equipment bay
for easy access to components like the
CLEARRAY System and the Quick Drain
Valve, Figure C. Place the panel in a safe
location to prevent from damaging it.
4. To reinstall the panel just follow the steps above in reverse
order.
13.3

Draining And Refilling

About every 3 to 6 months, you will should replace the hot tub's water.
The frequency depends on a number of variables including the amount
of use, attention paid to water quality maintenance, etc. You will know it
is time for a change when you cannot control sudsing and/or you can no
longer get the normal feel or sparkle to the water even though the key
water balance measurements are all within the proper parameters.
CAUTION! READ THIS BEFORE DRAINING: To decrease
!
damage to the hot tub's components, turn off power to the hot
tub at the circuit breaker before draining it. Do not turn the
power back on until your hot tub has been refilled. There are
certain precautions to keep in mind when draining your hot
tub. If it is extremely cold, and the hot tub is outdoors, freez-
ing could occur in the lines or the equipment (see "Winter-
izing", page 42). On the other hand, if it is hot outdoors, do
not leave the hot tub's surface exposed to direct sunlight for
long periods.
Draining Procedures:
1. Turn off power to hot tub at breaker.
2. Locate the 3" gray drain valve cap on side of the hot
tub cabinet. Unscrew drain valve cap to expose the
underlying male garden hose fitting (Figures A-B).
3. Attach female garden hose end to drain fitting and
route opposite end of garden hose away from hot tub
(Figure B).
4. Pull outward on garden hose end at drain connection
(approx. 3/8") to open drain valve and release water
from hot tub (Figure C). Water
drains at approximately 3 gallons per minute.
5. After hot tub has drained, close drain valve by pushing
inward on garden hose end at drain connection until
you feel it bottom out. Remove garden hose and install
gray drain cap before refilling hot tub.
Note: The gray drain cap cannot be installed until the drain valve
is closed. Refer to "Hot Tub Fill Up Procedure" (page 16) for
recommended filling instructions.
880 EXPORT SERIES
SPA CONTROLLER
Page 39
Figure C

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents