Electrical Installation Instructions (230V Service) - Sundance Spas 880 Series Owner's Manual

880 EXPORT SERIES
6.0

Electrical Installation Instructions (230V Service)

IMPORTANT NOTICE: The electrical wiring of this hot
tub must meet the requirements of the National Electrical
Code (NEC) and any applicable state, local or country
codes. The electrical circuit must be installed by a
qualified electrician and approved by a local building/
electrical inspection authority in your state or country.
DANGER:
!
1.
PRODUCT DAMAGE OR ELECTRICAL FIRE.
This hot tub must be permanently connected (hard-wired) to the
power supply. No plug-in connections or extension cords are
to be used in conjunction with the operation of this hot tub.
Supplying power to the hot tub which is not in accordance with these
instructions will void both the independent testing agency listing and
the manufacturer's warranty.
2. The power supplied to this hot tub must be a dedicated circuit with no
other appliances or lights sharing the power provided by the circuit.
3. To determine the current, voltage and wire size required, refer to
Section 7.0 (page 15) for your specific hot tub model.
• Wire size must be appropriate per local/country codes.
• We recommend type THHN wire.
• All wiring must be copper to ensure proper connections. Do not use
aluminum wire.
• When using wire larger than 10 mm² (#6), add a junction box near
the hot tub and reduce to short lengths of 10 mm² (#6) wire to
connect to the hot tub.
4. To gain access to the hot tub's power terminal block, remove the four
screws (Maxxus™ and Aspen® models only) or the Quick Release
buttons (except Maxxus and Aspen models) securing the center
cabinet panel on the side of the hot tub under the controls. Then
remove the four control box door screws and door (Figure C, page
14).
5. Hot tubs with one main terminal block (Figure D, page 14) must be
supplied with 20 Amps.
Note: The 880 Series can be adapted to use higher amperage circuits
when available. Contact your Sundance Spas dealer for details.
6. Select the power supply entrance you want to use (Figures A-B,
pages 13-14) and remove the short cabinet panel from the front
of the hot tub, then feed cable through the large opening provided on
the bottom of the control box.
Page 12
TO DECREASE THE RISK OF SHOCK,