Table of Contents
Advertisement
GREASING CUTTER SHAFT – FLAIL MOWERS
Locate grease zerks on each end of cutter shaft(s), these are located on the
bearing cover. Normal conditions require one or two pump in each bearing, using
Lithium-Complex Extreme Pressure grease conforming to NLGI2-ISO 320
specifications. This is to be done with a standard grease gun daily or at 8 hour
intervals.
CAUTION: Over greasing may cause premature seal failure.
GREASING GROUND ROLLER SHAFT – FLAIL
Locate grease zerks on each end of roller tube at lower rear of head. Normal
conditions require one or two pump in each bearing, using Lithium-Complex
Extreme Pressure grease conforming to NLGI2-ISO 320 specifications. This is to
be done with a standard grease gun daily or at 8 hour intervals. CAUTION:
Over greasing may cause premature seal failure.
MAINTENANCE
Triple Flail Maintenance Section 4-16
Advertisement
Table of Contents
