Travis Industries 864 HO NB Diamond-Fyre Installation Instructions Manual page 7

14. Route the wires under the valve tray to the front of the fireplace. Make sure to route the wires under the
gas control valve. The wiring must not contact hot or moving surfaces. Make sure to pull all of the slack
out of the wires so they do not contact the bottom of the burner.
15. Connect the wires from the light tray to the terminals disconnected earlier from the back of the rheostat.
16. Replace the control panel (shown in step 8 above). Use lock-ties, if necessary, to keep wiring from
contacting hot or moving components.
17. Replace the concealment cover (shown in step 7 above).
Page 7 of 13
864 HO NB Diamond-Fyre Burner
Installation Instructions
17601700 — 2/27/14
(sku: 96900142)
© Travis Industries, Inc.