rotork CMA Series Quick Start Manual

CAUTION: Before commissioning
actuators fitted with the Reserve
Power Pack (RPP), please ensure
PUB094-019 is fully understood and
additional safety instructions are
followed where applicable.
REMOTE
Position Display
POS I T
START POINT
X
Until
CLOSE
LOCAL
1
THRSTC
THRSTC or TORQ C
OPEN
LOCAL
THRSTO
THRSTO or TORQ O
CLOSE
LOCAL
2
CL ACT
OPEN
LOCAL
OP ACT
LOCAL
3
CL LI M
These instructions enable the actuator to be
configured to suit the valve and must be carried
out before electrical start up. For complete
instructions refer to PUB094-019.
PUB094-022-00 Issue 08/18
Ensure the local control selector is set to
LOCAL during the commissioning process.
LOCAL
POS I T
or
LOCAL
TC 100
LOCAL
TO 100
LOCAL
CA LI M
LOCAL
OA LI M
LOCAL
CL LI M
E D I T
or
%
Select desired Torque/Thrust Close
E D I T
or
%
Select desired Torque/Thrust Open
E D I T
or
Select Force FRC or Limit LIM
E D I T
or
Select Force FRC or Limit LIM
E D I T
or
Move Actuator to CLOSE Position
www.rotork.com
CMA
Quick Start Guide
CML-1500 and CML-3000
LOCAL
E D I T
TC 600
%
Example set at 60% SAVE
LOCAL
E D I T
TO 600
%
Example set at 60% SAVE
LOCAL
E D I T
CA LI M
SAVE
LOCAL
E D I T
OA FRC
SAVE
LOCAL
E D I T
CL LI M
SAVE
A full listing of our worldwide
Rotork plc USA
Brassmill Lane, Bath, UK Rotork Controls
sales and service network is
tel +44 (0)1225 733200 tel +1 (414) 461 9200
fax +44 (0)1225 333467 fax +1 (414) 461 1024
available on our website.
email mail@rotork.com email info@rotork.com
As part of a process of on-going product development, Rotork reserves the right to amend and change specifications without
prior notice. Published data may be subject to change. For the very latest version release, visit our website at www.rotork.com
The name Rotork is a registered trademark. Rotork recognises all registered trademarks.
Published and produced in the UK by Rotork. POWTG0818
Range
LOCAL
THRSTC
X
LOCAL
THRSTO
X
LOCAL
CL ACT
X
LOCAL
OP ACT
X
LOCAL
CL LI M
X