Table of Contents
Advertisement
ELECTRICAL
CONSIDERATIONS
Power Cord
The power cord is a 3-wire grounding-type plug.
This cord will only fit into a grounded outlet, which
is a requirement for the Q-View Imager Pro. Do not
remove the grounding leg of the plug. Doing so will
void all warranty on the Q-View Imager Pro.
The Q-View Imager Pro requires a maximum of
2 amperes at 100-240 volts AC. The power cord
provided with the Q-View Imager Pro is for 120-volt
service. If you have a different voltage supply or need
a different power cord for any reason, please contact
technical support. Do not use an extension cord for
the Q-View Imager Pro. Ensure that all equipment
plugged into the same circuit as the Q-View Imager
Pro does not exceed the amperes of service, or you
may experience a tripped breaker or power failure
that could result in the loss of your image.
Before unplugging the power cord, make sure Q-View
Software is closed on the PC. Make sure the USB cord
is unplugged and the device is powered off by the
switch on the back of the Q-View Imager Pro. At this
point, it is safe to remove the power cord.
USB Cord
The USB cord connects the Q-View Imager Pro to the
PC, which controls and operates the Q-View Imager
9
Quansys Biosciences
Advertisement
Table of Contents
