Table of Contents
Advertisement
7
Setup Completion
Once the Q-View Imager Pro setup is finished, the
software opens with the Update Preferences dialog
box. Select your preferences and log in if user accounts
were enabled. If your Internet connection on any
computer running Q-View Software goes through a
proxy, specify these settings under Administration >
Network Settings. Your Q-View Software and Q-View
Imager Pro are now ready to use.
MOVING AND SHIPPING THE
Q-VIEW IMAGER PRO
Ensure there is no plate on the tray of the Q-View
Imager Pro and unplug all cords. The Q-View Imager
Pro weighs approximately 13.6 kg (30 lbs). Use both
hands and lift with your legs, not with your back,
when moving the Q-View Imager Pro.
In order to move or ship the Q-View Imager Pro,
there are several critical steps that should take place.
1. Ensure the new location meets the requirements
addressed in Placement in the Laboratory
(page 3)
2. Remove any remaining plates on the tray
3. Remove the glass cover
4. Remove the glass
5. Close Q-View Software
on the PC
6. Turn off the Q-View
Imager Pro using the
switch on the back of
the Q-View Imager Pro
7. Remove all cords from
the device
8. Insert
Imager Pro into the
provided plastic sleeve
9. Insert
cover
into
their
protective
the
Q-View
the
glass
and
glass
respective
sleeves
Quansys Biosciences
Advertisement
Table of Contents
