Panasonic AK-HRP1005G Operating Instructions Manual page 21

2 [AUTO] button
3 [BARS] button
4 [TALLY/CALL] lamp/button
5 [REF. RECALL] button
Use this button to perform auto white balance adjustment, auto black balance adjustment, or
auto setup.
Set the function to be adjusted under [ROP SETTING] > [AUTO BUTTON] in the ROP menu.
"AUTO BUTTON" (see page 112)
Status displays during auto white balance adjustment
On: Indicates that the auto white balance adjustment has started.
Flashing: Warns that the automatic white balance adjustment ended without
being completed.
When highlights and lowlights are lost, white balance is returned to its
previous value. When correct white balance cannot be obtained, adjust-
ment stops at the last obtained value.
Off: Indicates that the auto white balance has been adjusted correctly.
Press and hold the [AUTO] button during white balance adjustment (lamp on) cancels
n
adjustment and turns the lamp off. ("BREAK" appears on the picture monitor (PM) of the
CCU.)
Then the white balance value returns to the value it had prior to auto white balance
adjustment.
Status displays during auto black balance adjustment
On: Indicates that the auto black balance adjustment has started.
Flashing: Warns that the automatic black balance adjustment ended without
being completed. Auto black balance returns to the value it had prior to
adjustment.
Off: Indicates that the auto black balance has been adjusted correctly.
Press and hold the [AUTO] button during white balance adjustment (lamp on) cancels
n
adjustment and turns the lamp off. ("BREAK" appears on the picture monitor (PM) of the
CCU.)
Then the black balance value returns to the value it had prior to auto black balance
adjustment.
Status displays during auto setup
The setup status is output to the picture monitor (PM).
"Auto Setup" (see page 34)
Use this button to output the CCU color bar signal from the camera video output on the CCU
rear panel.
When the signal is a camera video signal or a color bar signal, press and hold the [BARS] but-
ton to switch to the TEST signal. To switch from TEST signal output to camera video output,
press the [BARS] button.
To select a CCU color bar type, select [SYSTEM CCU] > [BARS HD] or [BARS SD] in the ROP
menu.
"BARS HD" (see page 108)
"BARS SD" (see page 108)
Status displays
On: CCU color bar or On
Flashing: TEST signal On
Off: Camera video
Indicates the tally signal input.
You can also press this button to call the camera operator.
Tally lamp status displays
On (red): Indicates that a red tally or both a red tally and a green tally are being
input to the CCU's <COMMUNICATION> connector.
On (green): Indicates that a green tally is being input to the CCU's
<COMMUNICATION> connector.
Off: The lamp turns off when a call is received from the CCU or camera while
the tally is lit.
Press and hold this button to recall the reference setting information (reference file) of the
camera.
Assign the user file and factory file under [SYSTEM CAM] > [REF. RECALL] of the ROP
menu.
"REF.RECALL" (see page 106)
Status displays
On: Recalling
Off: When the settings have changed
- 21 -
Parts and their functions