Panasonic AK-HRP1005G Operating Instructions Manual page 135

Setting Procedure
1. Select the ROP for which you want to configure the connection settings in [Master ROP Number] (A).
Clicking displays the IP addresses of the ROP units that can be set. From the list, select the ROP whose IP address you want to
set.
Any of the units registered on the [ROP List] tab can be selected.
2. Click the [REFRESH] button (G)
The user name set on the ROP selected in [Master ROP Number] (A) is displayed in [Old User Name] (B).
The ROP factory default user name is "admin".
3. In the [New User Name] (C), enter the new user name to set.
4. In the [Old Password] (D), enter the password set on the selected ROP.
Entered characters are displayed as [*].
5. In the [New Password] box (E), enter the new password to set.
Entered characters are displayed as [*].
6. In the [Retype New Password] box (F), enter the same password entered in step 5.
Entered characters are displayed as [*].
7. Click the [SET] button (H).
The user name and password are set on the ROP selected in [Master ROP Number] (A).
When cameras with the user authentication function enabled are controlled, the user name and password that were set
here will be required.
Enter the user ID and password configured on the connected device.
- 135 -
Software