Advertisement
REPLACING THE FILTER CARTRIDGE
1. Press the Side Control ON/STANDBY button twice to switch
the projector OFF. Let the projector cool for at least 45 min-
utes (READY indicator will be green).
2. Switch the Main ON/OFF Switch to OFF and unplug the AC
power cord from the AC outlet.
3. Clean the dust from the projector and around the air vents.
4. Slide the Filter cover to access the filter (see figure at right).
5. Hold the finger grip and pull to remove the filter cartridge.
6. Place a new filter into position. Make sure that the filter
cartridge is properly and fully inserted.
7. Close the filter cover.
8. Connect the AC power cord to the projector and switch the
Main ON/OFF Switch to ON.
9. Press the ON-STANDBY button to switch the projector ON.
10. Reset the Filter counter (see instructions below).
NOTICES: 1) Make sure the filter cartridge is correctly inserted
into the projector otherwise, the projector cannot be turned on.
Do not block the air vents. Doing so may result in malfunction of
the projector. 2) It is recommended that dusty/smoky environments
are avoided when operating the projector. Usage in these environments may cause poor image quality.
When using the projector under dusty or smoky conditions, dust may accumulate on a lens, liquid
crystal panels, or optical elements inside the projector. Such conditions may degrade the quality of the
projected image. When the symptoms above are noticed, contact your authorized dealer or service
station for proper cleaning.
LX1000 Lamp/Filter Replacement Instruction Sheet
020-000168-01 Rev. 1 (02-2009)
3 of 4
Advertisement
